CCNA Practice Exam Test Sample – Question 288

Refer to the topology. Your company has connected the routers R1, R2, and R3 with serial links. R2 and R3 are connected to the switches SW1 and SW2, respectively. SW1
and SW2 are also connected to the routers R4 and R5.
The EIGRP routing protocol is configured.
You are required to troubleshoot and resolve the EIGRP issues between the various routers.
Use the appropriate show commands to troubleshoot the issues.

Study the following output taken on R1:
R1# Ping source
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to, timeout is 2 seconds:
Packet sent with a source address of
Success rate is 0 percent (0/5)
Why are the pings failing?

A. The network statement is missing on R5.
B. The loopback interface is shut down on R5.
C. The network statement is missing on R1.
D. The IP address that is configured on the Lo1 interface on R5 is incorrect.

All what you have to know for this question is that the correct answer is C ( The network statement is missing on R1. )

Correct Answer: C
Section: Troubleshooting

R5 does not have a route to the network, which is the loopback0 IP address of R1. When looking at the EIGRP configuration on R1, we see that the network statement is missing on R1.